North Group Support Center Help Desk Knowledgebase RTKITE FAQ
Setup a pair of RTKite for Moving Base RTK
Suggested knowledgebase articles:

Setup a pair of RTKite for Moving Base RTK

 

https://www.dropbox.com/s/ftl8a7dlh10ir1s/Conventional%20RTK.png?raw=1

 

https://www.dropbox.com/s/z7gg1865otp1bne/Moving%20Base%20RTK.png?raw=1

 

BASE SIDE, BOARD#1

 

1.   Setup Board#1 in the format “Moving Base” at 1Hz or 5Hz (Rover must match this frequency in their output)

 

https://www.dropbox.com/s/0p0jrnth9exhp5a/App-Moving-Base-0.png?raw=1

 

 

2.   Setup Board#1 in the desired some Base “Receiver Mode”

 

https://www.dropbox.com/s/dfjhbh4auhkq2dh/App-Moving-Base-1.png?raw=1

 

 

ROVER SIDE, BOARD#2

 

1.   Setup Board#2 in the desired Rover mode (UHF or AutoCaster)

2.   Choose same frequency in output than Base rate (1Hz or 5Hz)

3.   Choose Moving Base rate (1Hz or 5Hz)

 

https://www.dropbox.com/s/j94dams6suoopxz/App-Moving-Base-2.png?raw=1

 

 

Article Details

Article ID:
19
Category:
RTKITE FAQ

Related articles