Behaviour of the LED DL1 (COLOR RED)

Behaviour of the LED DL1 (COLOR RED)

The LED DL1 (COLOR RED) shows a blinking when the RTKITE unit is doing something (so mean, "wait, I'm busy").

It have the following activity:
 
1 - After the 10 sec of the startup, DL1 is blinking quick meanwhile GNSS chipset is being configured with the selected mode (for example, mode "Drone UHF" or "Drone CORS")
 
2 - After the 10 sec of the startup, DL1 is blinking quick meanwhile radio chipset of 1W is being configured. This step is optional, only if the radio chipset of 1W (optional) is enabled and attached. This step is after the above step 1, chronologically speaking.
 
3 - Meanwhile button is being press, DL1 is blinking.
 
4 - Meanwhile the RTKITE is preparing SD Card for record files... or closing these files, DL1 is blinking.
 
5 - Meanwhile is connecting to CORS, DL1 is blinking.

6 - Meanwhile the RTKITE is recording RAW observations to the SD Card, DL1 is blinking at the rate one single flash each 5 seconds.

7 - In addition to the step 6), when an event from camera (trough the Photokit) have been added to the RAW observations in the last 5 seconds, DL1 is blinking at the rate two flash each 5 seconds (instead of one single flash each 5 seconds as stated in step 6)