Knowledgebase
North Group Support Center > Help Desk > Knowledgebase
» Category: PPKOORD FAQ  (Go back)

» Articles in this category:

 
PPKOORD (AKA RTKITE PPK) PINOUT
Refer to following image for the Pinout of PPKoord     Pre-wired cable and connectors
USB Usage
The usage of USB Mini connector is to expose a USB Mass Storage disk for copy the RAW files from the board to the PC. Usage:With the power supply of GNSS stage unconnected, connect the USB Cable to th...
Menu by USB Cable
Menu by USB Cable   This board have a Menu for setup some features, accessible by the USB cable.Requirements: HyperTerminalHyperTerminal is installed with your Windows system. You can also download fr...
Update of FW PPKOORD
Update of firmware in board PPKOORD   For apply the update follow this procedure: 1) In a Windows PC, run the "Flash_RTKITE_PPK_1_3_5.exe" file 2) Connect the USB cable to board "PPKOORD" 3) Press but...
RTK with the output to "5 Hz Nav+IMU Custom"
RTK with the output to "5 Hz Nav+IMU Custom" For the PPKOORD with RTK activation, you normally use the main connector (Pin 4: RX TTL 3.3V) for inject the RTCM messages, at 115200 baud.But, if you choo...
 

 
Powered by Help Desk Software HESK, in partnership with SysAid Technologies