Knowledgebase
North Group Support Center > Help Desk > Knowledgebase

PPKOORD (AKA RTKITE PPK) PINOUT

Solution

Refer to following image for the Pinout of PPKoord

 

https://www.dropbox.com/s/dc7ywteqj3oxw1h/north_ppk_module_l1_l2_pinout.png?raw=1

 

Pre-wired cable and connectors

https://www.dropbox.com/s/cfayboi5vkduznl/RTKITE%20PPK%20Cable%20pinout.png?raw=1

Definition of the cable of 2 contacts (for be used with the pushbutton switch, https://www.dropbox.com/s/apjr1l34xzirbrj/boton.png?dl=0 )

PIN NUMBER COLOR SIGNAL DESCRIPTION
1 YELLOW SW P1 CONNECT TO THE SWITCH PUSH BUTTON (NORMALLY OPEN TYPE)
2 BLUE SW P2 CONNECT TO THE SWITCH PUSH BUTTON (NORMALLY OPEN TYPE)

 

Definition of the cable of 5 contacts (power & TTL port)

PIN NUMBER COLOR SIGNAL DESCRIPTION
1 RED VCC DC POWER INPUT, VALID INPUT RANGE FROM 6V to 19V
2 BLACK GND GROUND
3 GREEN TX TTL3.3V GNSS OUTPUT, INTERFACE TTL3.3V
4 WHITE RX TTL3.3V GNSS INPUT, INTERFACE TTL3.3V
5 BLACK GND GROUND
       
Related articles Is there any way to get the RTK Output Port (RS232) onto the same 38400 baud rate as the TTL (3.3v) RTCM port?
Update of FW PPKOORD
Firmware Update RTKITE
Behavior of the LED DL2 (COLOR GREEN)
There are any API for access the content of SD Card by cable?
Menu by USB Cable
Behavior of the LED DL3 (COLOR BLUE)
QUICK FAQ. REQUEST US TO ADD YOUR QUESTION HERE!!!
RTKite to Pixhawk integration guide
Article details
Article ID: 34
Category: PPKOORD FAQ

 
« Go back

 
Powered by Help Desk Software HESK, in partnership with SysAid Technologies